Exercise: Workshop Technology

Questions for: Workshop Technology

A plug gauge is used to check the diameter of shafts and studs.
A:
Correct
B:
Incorrect
C:
D:
Answer: B
No answer description is available. Let's discuss.
📖
📝
💬
👁️
The cross-section of a chisel is usually
A:
rectangular
B:
square
C:
hexagonal
D:
octagonal
Answer: D
No answer description is available. Let's discuss.
📖
📝
💬
👁️
The blank diameter used in thread rolling will be
A:
equal to minor diameter of the thread
B:
equal to pitch diameter of the thread
C:
a little larger than the minor diameter of the thread
D:
a little larger than the pitch diameter of the thread
Answer: C
No answer description is available. Let's discuss.
📖
📝
💬
👁️
The purpose of a riser is to
A:
deliver molten metal into the mould cavity
B:
act as a reservoir for the molten metal
C:
feed the molten metal to the casting in order to compensate for the shrinkage
D:
deliver the molten metal from pouring basin to gate
Answer: C
No answer description is available. Let's discuss.
📖
📝
💬
👁️
In average work, the tolerance produced by investment casting method is
A:
±0.05 mm
B:
+0.2 mm
C:
+05 mm
D:
+1 mm
Answer: A
No answer description is available. Let's discuss.
📖
📝
💬
👁️
Ad Slot (Above Pagination)
Quiz