Exercise: Traditional Drafting Techniques

Questions for: Traditional Drafting Techniques

The first step in creating a traditional technical drawing is to ________.
A:
draw a series of guide lines
B:
set up the miter line
C:
align the paper so that it will be positioned square to the parallel bar
D:
sharpen the leads in the technical pens
Answer: C
No answer description is available. Let's discuss.
📖
📝
💬
👁️
Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for________.
A:
circle templates
B:
triangles
C:
technical pens
D:
lettering guides
Answer: B
No answer description is available. Let's discuss.
📖
📝
💬
👁️
Referring to the fractional inches to decimal inches to millimeter conversion chart on page 55 what is the equivalent mm measurement of 3/16 inch.
A:
1.906
B:
4.7625
C:
5.958
D:
14.6844
Answer: B
No answer description is available. Let's discuss.
📖
📝
💬
👁️
An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
A:
1/4" = 1'-0"
B:
1/8" = 1'-0"
C:
1" = 100'
D:
3/4" = 1'-0"
Answer: C
No answer description is available. Let's discuss.
📖
📝
💬
👁️
In order to convert fractional inches into decimal inches ________.
A:
look on a metric conversion chart
B:
divide the numerator (top number) by the denominator (bottom number)
C:
check the engineer's scale
D:
all of the above
Answer: B
No answer description is available. Let's discuss.
📖
📝
💬
👁️
Ad Slot (Above Pagination)
Quiz